Gothic Torches/pair

There is nothing more interesting than a brace of torches blazing on the wall!  Trying to light a dungeon?  Phantom of the Opera’s secret passageway crying out to you to do in miniature?  Looking for a unique light fixture inspired by genuine Victorian pieces?  These torches tick all those boxes and more.  The torches themselves are a decorative metal case and held by an alloy metal HAND.  The flames light with a flickering LED bulb.  Each light fixture is lovingly hand made by Cherie and come as a pair.

My Gothic Torches are wired to run off of the included 6-volt 2xCR2032 button batteries but I’ve soldered in a resister so you can cut off the battery holder and wire them into a 12-volt DC electrical system without worry that they will pop!  To help you install these torches easily into your display, I only twist the wires to the battery wires and tape them with electrical tape.  You can easily pull the tape off, make a small hole in the wall of your display and poke the wires through then reconnect to the battery pack or your own DC electrical system.  Easy!  Instructional sheet also enclosed.

Measurements of one torch.  (Caveats:  Each torch flame is hand made and unique.  Some are wider and taller than others.  When I card up a pair I try to match the flames so they look good together.  Also, when I measured the depth (torch projection out into the room), I measured with the torch mounting plaque flat as if it was on a wall.  This measurement will vary a bit depending on the height and width of any particular flame.)

Torches measure approximately:  2.25″ Tall x 1 1/4″ Deep (tip of flame to wall) x 1/2″ Wide